Shop

BuildTak Bond for Polyamide (Nylon) and Polycarbonate

$24.99 $19.99

Need help getting your PA (nylon) or PC (polycarbonate) prints to stick? Our new solution can do the trick, and best of all, it works with your existing Original BuildTak Surface!

Meet BuildTak Bond for PA and PC! Just apply directly to your BuildTak surface of choice and heat the bed to 35-40C for 5 min to dry. Then print away.

Our BuildTak Bond is water soluble, so when you want to go back to another filament, just use warm water and a paper towel to remove the adhesive.

Purchase this product now and earn 20 Points!
SKU: BTB008 Categories: ,

Description

With this new BuildTak Bond, it is now possible to print PA (nylon) and PC consistently on the BuildTak Original Surface.

As you would printing with any filament, first you want to adjust the nozzle height so the first layer is perfect. You will ideally want to reach the ‘sweet spot.’

Apply 2-3 layers of ‘BuildTak Bond’ on the BuildTak Surface (as you would a gluestick).

From there, you simply heat up the bed. The bed temperature for when printing PA/Nylon is 40-65C and 75C-90C for PC. Wait several minutes until the adhesive layer becomes darker/translucent.

That’s it, you’re now ready to print PA/Nylon and PC on your Original BuildTak Surface!

Additional information

Weight .14 lbs
Dimensions 1.16 × 1.16 × 4.44 in

Reviews

There are no reviews yet.

Be the first to review “BuildTak Bond for Polyamide (Nylon) and Polycarbonate”